Alarm Programming Codes

Just to make you aware of a couple of toys on the sti alarm.

using the keypad on the driver side with the ignition switched off.

door unlock/locking beeps
*17856 wait for the beep *000*1# turns the beep on when locking and unlocking although admittedly not very loud

Auto arm with door locking 60 seconds after the last door has been closed, Note make sure keys arnt in the vehicle.

*17856 wait for the beep *004*1# turns it on. everytime a door is opened it will beep twice to inform you that its active

Safety Lock/Unlock (locks the doors automatically - single lock - when the ignition is on/car is started).

Very easy -

Turn on the ignition
Press 7 on the keypad
Turn off the ignition

JOB DONE!

Brian.

To turn the beep up and down:

Ignition on
Press the star button on the keypad (toggles between soft and loud)
Ignition off

i am liking these codes.
keep them comming..........

carlos..

wrxmania wrote:Safety Lock/Unlock (locks the doors automatically - single lock - when the ignition is on/car is started).

Very easy -

Turn on the ignition
Press 7 on the keypad
Turn off the ignition

JOB DONE!

Brian.

Wonder if that works on mine. which ignition setting (1st pos or 2nd) and how long to press 7 for?

Can confirm that the auto lock works on the WRXD.

Yes it does work as they still run the sigma alarm setup

Found it!

Knew it was on here....

Was looking to set the alarm confirmation beeps on, the alarm system manual says this is only on non EU cars ??!!

Have to try it and see!

its basically turned off when the car enters the uk as they say its not allowed to beep. but i just turn them back on by request only